|
Searched The Old-House-Friends Forums for "drains"
|
Found 69 matches
|
|
<< Previous 10
| Viewing 1 - 10 of 69
| Next 10 >>
|
|
|
|
|
|
I am in process of taking old paint offmy old floor. My basement is 26wide by 36 long by 8 high. My question is my floor is uneven and I have 3 drains in my floor and I want to relevel my floor,is this a good idea. My 2 drains sit about 2 inches lower what should I do.
|
|
read more
|
|
|
|
|
|
|
My house is about 40-45 years old. The drain in my basement floor is running very slow. I got in there with a snake and found that I could only put about 1.5 feet of a 15 foot snake down the drain. I assumed I had hit the clog and began working on it. After pulling out some gunk, I used a metal pole...
|
|
read more
|
|
|
|
|
|
|
It depends, im assuming the floor is concrete, if so then remove the paint,then clean etch the existing floor, remove the drains,insert PVC pipe into drain holes to 24 above existing grade,cap off PVC. using a transet or 6 level mark your new height around perimeter ( go at least 2 above highest exi...
|
|
read more
|
|
|
|
|
|
|
Hello, I hope someone can help me, I´m lookig for a particular drain for a sink, its a kind of spud of 2 3/4 diameter thah fits under the sink whitout a screw coming from the top of the sink, I mean, this spud fits under the sink. I have a non drain hole sink and need this kind of drain, well, by un...
|
|
read more
|
|
|
|
|
|
|
I have a cast iron tub which I need to trade. Its 60 long with a finished, round end. Its meant to be mounted into a corner rather than an alcove. My challenge is that the one I have is a right hand drain. (Meaning that the drain is to the right when facing the finished side of the tub with the roun...
|
|
read more
|
|
|
|
|
|
|
I am looking for a tub drain that connects at the base of the tub with a 2 spud. There is no overflow and the tub is cement. All controls are on the outside of the tub. The drain works like a plunger. It has a porcelain knob and sets into a 2 shaft. Any advise would be helpfull. thank you.
|
|
read more
|
|
|
|
|
|
|
I am looking for a bathroom sink drain spud for a 2 3/4 drain diameter with a debth of 2 1/2. Can anyone out there help? My husband is trying to have me throw out this beautiful old sink! I have a $1000. bet with him that I can find it!
|
|
read more
|
|
|
|
|
|
|
So, if you are sure the drain is sufficient, there are a couple things to consider. I have taught this to several people. The newer ULF, (Ultra Low Flush), toilets were invented in Europe where people seem to be a bit more interested in conservation, (I think this is because everything is more expen...
|
|
read more
|
|
|
|
|
|
|
I installed a new toilet and there is no suction. I checked the drain and it is not clogged.
|
|
read more
|
|
|
|
|
|
|
Thanks for the offer but I need a white, right corner, right hand drain, 5, cast iron tub. Sabrina.
|
|
read more
|
|
|
|
|
<< Previous 10
| Viewing 1 - 10 of 69
| Next 10 >>
|
|
|
Searched The Old-House-Friends Forums for "drains"
|
Found 69 matches
|
|
|
